Pairing the LYPERTEK TEVI
- Double tap either earbud to start pairing.
- Go to Bluetooth settings on your device.
- Turn Bluetooth on.
- Select LYPERTEK.
- You're good to go.
Resetting the LYPERTEK TEVI
- Forget the TEVI bluetooth name, [LYPERTEK] TEVI - L / R, from the Bluetooth list on the phone.
- Put both earphones into the charging case; (Make sure the charging case has power)
- Press and hold both TEVI L/R for 5 seconds. Remember to make sure you can see the light.
- Once you see the light flash, release the fingers. Then TEVI was reset.
- Take out both earphones from the charging case, LED of one side earphone is flashing, which means it is at pairing mode.
- Follow the pairing procedure to connect TEVI with the phone again.